GoUP!.gcode

Just some simple Gcode to move the head up to access the bed for double Z printers that don't have commands for that (like with Marlin

goUP!.g>>>>move up 100mm
goUP!50.g>>>>move up 50mm
goUP!200.g>>>>Z home and move up 200mm
goUP!50HeatUP>>>>move up 50 and heat up to 200°C

Very easy to code for beginners using "control+F" and searching commands on this website: https://reprap.org/wiki/G-code

Of course you can modify it using notepad or others to adapt it to your needs !

For reducing time to achieve, there's no homing before (G28 Z).

Disclaimer: I am not responsible of any of the damages that can cause this gcode. Especially if you don't home the printer before, keep in mind that the printer can go too far and block the Z motor !