Übungs Ohrthermometer für Fallbeispiele

thingiverse

Training Thermometer for Emergency Response or Other Medical Fields. Since medical devices must undergo a yearly STK inspection for training purposes, multiple Training Thermometers will be very expensive in the long run. The measured values are typically entered by the trainer anyway. The measurement tip of the thermometer must be attached afterwards. Therefore, it is also possible to print without Dualextruder. The body contains an installation lever: Installation height max. 23mm Thread diameter 6-8mm Total diameter 17.5mm The lid is held in place by two M3 x 10mm thread screws with nuts at the bottom of the body. It has a bore for the piezo buzzer and one that makes it easy to remove the lid. The lid contains an active 3V DC Piezo Buzzer with a diameter of 8mm. The buzzer should be fixed with a small drop of hot glue. A CR2032 battery is used as a power supply. The holder for the CR2032 can be attached to the plate on the lid. For the entire print, NO support is required. Only a Brim from 20mm is recommended due to the height! I would appreciate a small PayPal donation!