µDiva

thingiverse

This project demands extensive close-quarters building and soldering expertise, so be prepared for a potentially frustrating experience. These files outline the necessary components for crafting the Micro Diva's frame. The build requires seven regular brackets and one of each additional part listed below. Two back plate options are available: one with a 4-pin mini XLR hole and another without to accommodate USB wire placement. Raster cutting around the touch slider area on the face plate, approximately 1-1.5mm deep, enables the slider's secure fit. The uDiva logo is also embedded for painting but can be removed or altered as desired. To complete this build, you will need to print two brackets specifically designed to hold the slider in place. Additionally, the following parts are required: Seven 1/4(6.35mm) buttons Four Seimitsu PS-14-DN buttons, available in a variety of colors One Brook PS3/PS4 Fight Board PCBA One Brook Touch board (typically found on eBay, featuring a green PCB center) One USB cable with optional 4-pin mini XLR male and female connectors A pack of M2 bolts measuring 12mm in length A pack of M2 bolts measuring 8mm in length A pack of M2 nuts