ZX Spectrum 16k/48k wall mount

thingiverse

This is a wall mount for the Sinclair ZX Spectrum 16k or 48k. Since the computer is very light, you can probably just mount it into drywall anchors, but I still prefer to screw it into a stud. The design allows the computer to be taken down to be used without removing the wall mount. If you rotate the model 45 degrees and reduce the distance between the model and the skirt to just a few mm, you can fit it on the bed of an Ender 3 and print it fully without supports. For other printers, you may have to get creative and print it on its back or on its side, but this will require lots of filament wasted as support materials. You should be able to print this in any filament you like. Black matches well with the computer and I printed in PETG just to get rid of a roll that I never use.