Zuca Cart Retriever/Umbrella mounts

thingiverse

Zuca Backpack Cart Upper and Lower supports for Retrievers/Umbrella I started off making these as clip ons but even with 4 and 5mm thickness i was getting snapping so i decided to make these as mounts. I have found that it takes only a couple minutes to remove the needed hardware from the cart to install and only a few seconds to install. This made me more comfortable about the overall design and longevity of the item. Upper Support Designed to slide over the cross-member that connects the left and right sides of the cart. *** This requires the removal of the single allen bolt on the side that it will be installed on.*** Opening is 45mm wide and should fit most umbrellas and all retrievers. It is a very snug fit so a little dish liquid may encourage it to slide on a little easier. Lower Support This is designed to slide over the bottom pole of a Zuca Backpack cart(though i would imagine the other Disc Golf carts from Zuca use the same size poles) and come to rest on the horizontal bar at the bottom. ***This requires the removal of the (2) allen bolts that hold the thumb screw on before attempting to install.*** Installs from top down. The left and right pockets are wide enough to accept a number of umbrella handles and should also fit all disc retrievers. The holes are tapered for any retriever/umbrella to center up while providing drainage for an liquid than may get in. Tried to get "thingiview" but all answers i found out on the interwebs have failed if you have a sure fire way please feel free to share with me.