Zortrax M200 extruder cable + filament holder

thingiverse

Zortrax M200 extruder cables tend to wear out quite fast. The issue starts when the extruder fails to extrude properly or gets stuck in the heatbed and won't stop. This happens because the cable breaks near the extruder connector. This is a really useful addition for the printer, and holding the cable in place with textile tape makes it work even better. However, do not use painters tape as it leaves behind a sticky residue that can be a real problem if left out in the sun after some time. If you have a broken extruder cable, contact your reseller or Zortrax directly using this form: http://support.zortrax.com/support-form/. They will replace it under warranty. This model was found on Thingiverse last year but has since been taken down for unknown reasons. We know that the original author left their name as CryptoBot2015 on the model itself, so we'll give them credit for the work they did. Print Settings: Printer: Zortrax M200 Rafts: Yes Supports: Yes Resolution: Any Infill: Any Notes: If you already have a Zortrax printer, you can find a .zproj file in the download section.