ZooMed Reptifogger Replacement Flask

thingiverse

This is a 2-liter flask to replace the 1-liter flask that comes with the ZooMed Reptifogger. Replace stock silicone seal with 3/4"x1" (#20) o-ring to maintain proper seal. HAZARD STATEMENT: Using this fitting for potable water is potentially hazardous due to the potential for chemical leeching and bacterial contamination. If using for potable water sources, avoid use of leaded brass nozzles and use only food safe filaments that can be sterilized between each. **TABLE OF CONTENTS** - Included Files - Additional Hardwae - Printing Details **Included Files** - Readme.txt - Humidifier flask.stl and .step **Additional hardware** - 3/4"x1" (#20) o-ring **Printing Details** - Material: Fiberlogy CPE-HT recommended - Parameters: Layer height: 0.25mm Wall thickness: 1.8mm Top and bottom thickness: 1.8mm Infill: 100% lines - No supports, no brim, no raft - STL'S are oriented and scaled correctly for printing, just drop on build plate and slice. - Calibrate flow using the 2-wall method (shown at https://3dprintbeginner.com/flow-rate-calibration/), round up to the nearest whole number and add 1%. For example if the calculated value is 97.4%, round up to 98% and add 1% to make 99%. Put 99% into the flow setting on your printer or slicer. - Calibrate dimensions using my sizing calibration worksheet found here (download and then edit): https://docs.google.com/spreadsheets/d/1uzxgxDTHeHwxTcNySJS7T-__f5-2h0hM/edit?usp=sharing&ouid=103628261456516391499&rtpof=true&sd=true This work is licensed under Creative Commons Attribution Non-commercial. I hope you enjoy my work! https://odysee.com/@Tavelkyosoba:b