Zonestar LCD Controls Box Relocation

thingiverse

Hello again, this is a custom LCD relocation for the zonestar P802NR2. I've positioned my printer to maximize control accessibility. Several designs were available on Thingiverse, but theirs had button holes too far from the LCD screen's edge. Check your spacing before printing and wasting filament like I did - mine is 5 mm from the first button. This relocation was designed in 123Design to meet a specific need. It doesn't include screw holes for securing the screen; you can use double-sided tape or small screws instead. I chose screws, drilling a small hole with a drill bit due to the light infill. Avoid over-tightening the screws since it's so lightly filled. The Box back fits snugly, requiring no additional holding mechanisms, but it is challenging to open. Print Settings: Printer: Dremel 3D20 Rafts: No Supports: No Resolution: .3 Infill: 15%