Zomei winder/gear/pin to raise it up

thingiverse

Ive been staring at my Zomei Q11 tripod for almost a year and currently am recovering from a car accident so have lots of time just sitting. So i decided to tackle this project. And it turned out near perfect on my first try. I had to adjust the pin hole by .25MM so this is V2 but barley! It fit perfectly for V1 but i had to sand a little bit of martial off so the handle would fit! Hopefully this will help someone else too! Pro tip. Print it standing upright with wides part facing down. Otherwise supports will make it look messy on one side though will still work. Can see what I mean in second picture. Printed one in each orientation as on its side would be stronger. If you do print on it’s side you’ll need sandpaper and possible a file to tidy it up a bit. As the one I printed standing upright worked fine I didn’t bother to finish it.