ZOHD Dart VTX and Antenna Mount Kit

thingiverse

<p>ZOHD Dart VTX and Antenna Mount. Designed to place weight in front of the CG, as the dart tends to be tail heavy.</p> <p><u>If you found this useful, please consider buying needed parts through my affiliate link (or make any purchase at the website below after visiting these links)</u>:</p> <b><a href="https://www.banggood.com/custlink/mmK3UqU7Dl">Eachine TX805</a></b> Budget Choice VTX - Measured 1 unit to be @250mw output. Still had a good FPV experience <3km. <b><a href="https://www.banggood.com/custlink/3vKvqzquGb">AKK FX2 International</a></b> Intermediate Choice VTX - Measured 2 units to be @650mw and @890mw output. Installed on most crafts, comes without heatsink and with a straight MMCX connector. <b><a href="https://www.banggood.com/custlink/3Km3zUM1En">Eachine TX805s</a></b> Best Choice VTX - Measured 1 unit to be @1190mw, but dropping to a few DB below at an instant. Comes with heatsink installed and a right angle MMCX connector. <b><a href="https://www.banggood.com/custlink/mmKKkq21PK">Realacc Antenna Set</a></b> Good Budget Antenna by Realacc that I have good experience with. <b><a href="https://www.banggood.com/custlink/DvvKkzUfS3">Foxeer Lollypop Antenna Set</a></b> Good and Small Antenna by Foxeer that I have had good experiences with. <b><a href="https://www.banggood.com/custlink/D3mDUqzaaU">Hex M2.6 Self Tapping Screws</a></b> Get a whole variety of these screws, neat to use with 3D printed parts and used on all designs. Two 8mm screws were used with heatsink around the top for better fit. <b><a href="https://www.banggood.com/custlink/3GKK2UlTeU">The RF Meter that I used</a></b> Cheap at only 30 or so euro's and does a simple job. Order <a href="https://nl.aliexpress.com/item/32881279549.html?spm=a2g0s.9042311.0.0.27424c4dAO34rL&fbclid=IwAR1-_yDUN6VvyJoF3qXHbljxcvyqNmSZxd9NwIIDxIp41VJLqg-QO0CpWnw">this attenuator</a> with it.