ZOHD Dart 250g ESC Cover With BN-880 and CaddX Vista Mounts

thingiverse

ESC cover for the ZOHD Dart 250g that integrates a BN880 mount and a Rush FPV Cherry (CaddX Vista) FPV antenna mount I glued M2 threaded inserts into the foam, and the ESC cover attaches using M2 cap screws. You may want to use a flexible/removable adhesive or thin double sided tape in addition to the cap screws, so you don't tear the inserts out in a hard crash. You will need to use the mount/adapter that comes with the Rush FPV Cherry antenna (Caddx Vista antenna) and two M2 nuts to mount the FPV antenna. This configuration will have your Vista unit or VTX below the air duct on the fuselage. If you're using a CaddX Vista, you will need a 20cm CaddX Vista Coaxial Cable. The BN-880 I am using is a single PCB version. I also have a thicker BN-880 that has two PCBs - the thicker version can fit but it is tight. I would not recommend using the magnetometer in the BN-880, since it is mounted very close to the motor and ESC. I printed this at 0.2mm layer height in PETG filament. You can print at a smaller layer height, but do not print at greater than 0.2mm layer height because the main cover is only 0.6mm thick. This STL should be printed flat on the build plate, with supports.