ZMR250-XT90 and Antennaholder combo

thingiverse

Inspired design by https://www.thingiverse.com/thing:1550668 but tailored to work seamlessly with XT90. What sets v2 apart from v3 is that the angle of the mount, where the XT90 resides, is more upright than ever before. What distinguishes v3 from both v1 and v2 is the fact that the mounting holes are 1.5mm further back and boast a sturdy 3mm thick baseplate instead of a mere 2mm. The reasoning behind these three versions revolves around thorough testing. v1 demands a perfectly straight edge on the carbon plate it attaches to. With v2, you'll find a bit more breathing room, while v3 offers even more space to work with. Printing time comes in at approximately 30 minutes, courtesy of ironing, tree support, a brim of 5, and adaptive layers. If you encounter any issues with this part, simply reach out for either the source file or suggestions for improvement – I'm here to help!