ZMR250 vTX & MinimOSD mount

thingiverse

Two custom-designed trays for the MinimOSD and video transmitter modules like the ET200, LT200 and similar sizes are now available. These trays can be easily inserted between the four rear pillars of the ZMR250 frame, with no need for additional vertical support as they securely fit in place due to sufficient friction. Small notches on the trays allow optional securement of the modules using a cable tie. It's worth noting that I created these custom parts specifically for my vTX and OSD units, which lacked buttons and had unique pin headers soldered directly onto them. Check out this design detail to see how the headers were configured on my original MinimOSD board. Update: I've added a cutout at the end of the MinimOSD board that accommodates standard MinimOSD modules. Now, you can seamlessly integrate these trays with your setup! Update 2: I've introduced a new design featuring a single tray that supports both vTX and MinimOSD modules, necessitating angled pins on the latter to facilitate fitting. Update 3: The tray for the vTx has been redesigned to be slightly wider, with an added hole for cables of servo connector width, and a cutout enabling access to the frequency/channels change button. Update 4: As requested by leofaoro, I've incorporated a design version pushing the vTx further towards the rear. Your feedback is highly valued - please share your thoughts on this design and let me know if you decide to manufacture one!