ZMR250 Quadrocopter Spacer-Set 3mm

thingiverse

I needed a solution to bridge the 3mm gap between the bottom plates, since every hard landing had me digging out dirt from underneath. These parts fit snugly between the bottom-plates of a ZMR250 Quadcopter; however, you'll need longer M3 screws for the aluminum spacers, as 10-15mm lengths will suffice. This design is optimized for 3mm-arms. The rear spacer features a holder for two Diatone LED-boards (7x30mm, 12V); simply attach these boards to the holder using hot glue. The VTX-holder (available at http://www.thingiverse.com/thing:1599815) will fit perfectly behind the LEDs. Added midship-spacer: This component seals the gap beneath the flight controller and middle spacers. Use M3x10mm screws to secure the posts and PDB/flight controller, allowing you to remove your FC without disassembling the bottom plates. Print Settings Printer: CTC 3D Printer, Makerbot Dual clone Rafts: No Supports: Doesn't Matter Resolution: 0.20mm Infill: 20% or more Notes: PLA