ZMR Insect antenna holder

thingiverse

I was fiddling with my ZMR and the stereo antenna holder I made, thinking, "this just won't cut it!" Got some longer batteries and noticed a snug fit between the antenna holder and my custom XT60 holder/antenna. Figured it's time to make a new antenna holder and move the antenna to the very front two screws on top. I think this setup works perfectly even with a small cam on top. Those antennas will be out of sight (I hope). This modification makes the ZMR look like a cyclops insect. Print with ABS or whatever 0.25/0.27mm, 15% infill in 8 minutes - no supports needed. Used some heat shrink to route the antenna wires past the sharp frame edges. Note - all you need is an exposed tip sized to the wavelength; do what you want with the leads as long as those tips are visible. This should work on the QAV 250 too.