ZiS-2 57mm for 15mm scale wargaming - remix

thingiverse

I've thickened the barrel, remade a thicker armor plate, reinforced some controls, wheel axles, and rear supports on the model. These enhancements are merely replacing parts with heavier ones, without reworking the mesh due to its density and detail. The wheels and rear section have been slightly rotated to sit at ground level. I've also noted that the rear extensions appear to be a bit short, so I had to adjust the scale size based on height and wheel width. This print was done with a 0.08 layer height, 20% infill, and a 40mm print area using experimental Cura support settings. It's estimated to take around 38 minutes (according to Cura). However, I need to update my settings as there was quite a bit of stringing on these prints, along with the Cura supports.