Zinc 2.0 Improved Magazine

prusaprinters

<p>I often found some of my prints of the 7 round mags for the Zinc 2.0 are slightly too short meaning they won’t catch properly. Previously I carved out the catch slot on the mag a bit with a scalpel, but this caused other problems such as the mag ejecting when the slide was pulled back too fast.&nbsp;</p><p>This mag has 0.5mm of extra length inserted in the middle so that there is room for tolerance, and your mag will catch every time, straight from the printer. There may be a tiny gap between the base of the handle and the mag base, but it is barely noticeable.&nbsp;</p><p>&nbsp;</p><p><i>All improved/modified parts for the Zinc 2.0 from me:</i></p><p>Improved slide: <a href="https://www.printables.com/model/251754-zinc-20-improved-slide">https://www.printables.com/model/251754-zinc-20-improved-slide</a>&nbsp;</p><p>Improved mag base (for 7 round mags): <a href="https://www.printables.com/model/250171-zinc-20-thicker-mag-base">https://www.printables.com/model/250171-zinc-20-thicker-mag-base</a>&nbsp;</p><p>Extended mag base (for 10-13 round mags): <a href="https://www.printables.com/model/250170-zinc-20-extended-mag-base-thicker">https://www.printables.com/model/250170-zinc-20-extended-mag-base-thicker</a></p><p>Improved 7 round magazine: <a href="https://www.printables.com/model/307436/edit">https://www.printables.com/model/307436/edit</a></p><p>Improved mag follower: <a href="https://www.printables.com/model/305932-zinc-20-improved-mag-follower">https://www.printables.com/model/305932-zinc-20-improved-mag-follower</a>&nbsp;</p><p>Improved mag release: <a href="https://www.printables.com/model/308140-zinc-20-improved-mag-release">https://www.printables.com/model/308140-zinc-20-improved-mag-release</a></p><p>&nbsp;</p><p><i>Zinc 2.0:</i>&nbsp;<a href="https://118.design/ZINC-2-0-Hardware-Kit-p381436673">https://118.design/ZINC-2-0-Hardware-Kit-p381436673</a></p><p>&nbsp;</p>