Zimmant MP MINI Top Mount Spool Holder

thingiverse

This is a top mount spool holder for the MP Select Mini, created by fusing my own design with the "Badass Spool Holder" and the "Mp Mini Tool Holder". It's not yet complete. The two mounting holes closest to the right side, when facing the machine's front, are slightly off and require some reaming to match the Mini's threads with the mount holes. Additionally, where the two main frames meet, the joints are quite basic since this was my first design made in Tinkercad. I used 2-M3x30 screws and nuts, and you'll need a needle nose plier to hold the nut while securing the screw. It's also suggested that the spool parts be lengthened as some rolls of filament are too wide for the "badass spool's" recommended 1/4-20 rod length. At least another 10mm in length on the sleeve and adjust the short and long tubes to make up for it is recommended. Parts and assembly for the "Badass Spool Holder" can be found here: http://www.thingiverse.com/thing:1729524 Printer Settings: Printer: MonoPrice Select Mini Rafts: No Supports: Yes Resolution: 0.2 Infill: 30-100% Notes: I used manual supports for the tool holder on the top base. Other than that, no support should be needed. Also, I printed the top base at 100% because I wanted the very top to be solid. If you have S3D, you could do two processes and change to 50% after the top flat portion is finished to save some filament. The large arm I used 50%. And all other files were 30%.