Zigbee 4 Button Light Switch Mount

prusaprinters

This is a non-destructive holder for the HIMOJO Wireless Scene Switch that uses your light switch plate's screws as a mount.You may notice a few identical Zigbee-compliant products from different brands. This is because they use Tuya designs. This holder can potentially fit other identical-looking 4 button switches. Check the dimensions below to make sure.Switch dimensions:Width: 86mmDeep: ~13.2mmAssumptions:Screw Hole Distance(center to center): 31.5mmLight Switch Plate Depth: ~6.7mmPrint:Material: PLA testedSupports: YesBed Adhesion: Skirt used. Use brim if you have bed adhesion issues.Orientation: Facing upEnable ironingInstall:Remove both screws from the top of the switch plate.Insert the 4 button scene switch into the rear of the mount, top first. The small lip at the top-rear should hold the 4 button switch in place when installing and using. It's normal for the print to flex a little when pressing the switch into it.Line up the holes on the print to the light switch plate.Hold the mount in place and screw the screws back into the holes. Do not over tighten.