zesty nimble to v6 hotend clone direct mount

thingiverse

This enables the zesty nimble v1.2 to mount directly onto an E3D V6 clone. It's specifically designed for the left-hand Zesty setup. The coupling thread measures M10x1mm (despite the hose fitting being G1/8-28, the actual thread size is not). A PTFE tube with a length of approximately 45mm makes up the assembly. For mounting, two M3 bolts measuring 33mm in length are required without the tube holder, while two M3 bolts measuring approximately 46mm (in length) are needed when using the tube holder. Note that holes are oversized by 0.2mm to accommodate various printer designs. The M10 thread was modeled at its actual size, which provides a slight friction fit within my heatsink (from my own printer). A spacer insert is also designed as a tight fit. This is just a test piece; any feedback from users would be greatly appreciated.