Zerowater tap button presser

prusaprinters

If you have a Zerowater dispenser system, then you know this button for the tap. It's fine if you just want a small cup of water, but if you say, need to fill a 4L jug, your thumb is going to be numb by the end.This is where my Zerowater tap button presser comes in!It converts the button press tap to a screw driven tap. You screw it in to get water, unscrew it to stop.Printing InstructionsUse the Place on Face feature to arrange the models in this orientation.Then you will need to add support to the clip. I did manual supports because I don't want it going crazy adding too much.I added supports in the above areas using the small fill with only overhangs feature. I did also set support XY separation to 100%. Then of course in generate support for support enforcers only.I used PLA, printed at 0.2mm layer height, 3 walls, 3 top and bottom layers, 20% infill.No support is needed for the screw part.