ZeroPiCamHQ

prusaprinters

<p>This is my idea of a case for the Raspberry Pi HQ Camera in combination with a Raspberry Pi Zero W for using the Raspi as WebCam.<br/> There is a nice project called showmewebcam which turns your Raspberry Pi Zero/W into a webcam:</p> <p><a href="https://github.com/showmewebcam/showmewebcam">https://github.com/showmewebcam/showmewebcam</a></p> <p>Design-Goals were:<br/> 1) Small front footprint<br/> 2) can stand on a flat surface without mount and don't tip over to the lens (depends of course on the lens)<br/> 3) should look nice<br/> 4) all screws from the camera module should be reachable<br/> 5) hidden camera cable<br/> 6) should be easy adaptable to other Raspberry Pis or useable without direct attached Raspberry</p> <p>I hope you enjoy it!</p> <h3> Print Settings</h3> <p><strong>Printer:</strong></p> <p>HEVO</p> <p><p class="detail-setting rafts"><strong>Rafts: </strong> <div><p>Doesn't Matter</p></div><strong>Supports:</strong></p> <p>Yes</p> <p><p class="detail-setting resolution"><strong>Resolution: </strong> <div><p>0,2mm</p></div><strong>Infill:</strong></p> <p>yes</p> <p><strong>Filament:</strong> Extrudr PLA <br/> <p class="detail-setting notes"><strong>Notes: </strong> </p><div><p>The front lid should have a little bit of flex to get it easier around the camera.<br/> I printed everything with white PLA which gives a nice contrast to the HQ Camera Modul.</p> <p>The back case i printed with support for the USB Port. But if you tuned your printer well, it should also be fine without support.</p> <p>The USB Port and the SD Card Port are designed with little cut-throu-walls.</p> <h3> Post-Printing</h3> <p>To assemble everything, you need</p> <p>two M2.5 12mm screws<br/> two M2.5 20mm screws.</p> <p>The screws go from the very back to the front in the lid.<br/> I first cut the threads in the back and the middle.<br/> Then i pushed carefully the lid around the camera module. This should sit flush around the tube. Maybe some sanding is required because the tolerances are quite small. Depends on your printer.<br/> Connect the camera module to the Raspberry Pi.<br/> The USB Port and the SD Card Port are designed with a little wall. Cut them out.<br/> Screw the 20mm screws in the lower holes until they are flush with the backcase.<br/> Put the Camera-Module with the lid into the case. The holes should all be aligned.<br/> Push the raspberry into the backcase, hold everything together and screw everything together.</p> </div></p></p></p> Category: Camera