Zeratul's Warp Blade From Starcraft 2

myminifactory

You'll find assembling this project a breeze, thanks to the convenient pegs that facilitate precise alignment of the components. To complete the build, you'll need to print six large pegs and two small ones - the latter being essential for securing the attachment piece due to space constraints. The attachment mechanism relies on magnets, with slots available for four 6mm (diameter) x 3mm (height) and four 10mm (diameter) x 3mm (height) magnets on each side. Although I only utilized half of these slots because my chosen magnets proved sufficient, you can opt to fill all the slots for added security. The hand slot measures 12x12cm at the back and approximately 11x8cm at the front, allowing it to accommodate most hand sizes despite being a bit loose on my arm. Additionally, there are provisions for attaching 1-inch wide webbing straps to secure the base piece to your arm, enabling you to move freely without restriction.