Zeldathon Recovery Triforce Bas Relief Ring

thingiverse

While watching #Zeldathon Recovery, I designed a ring featuring an opposing Triforce emblem. If you appreciate this unique design, consider making a donation to Zeldathon! Be sure to mention your source in the comments. For those unsure of how much to contribute, $3.00 is a suggested starting point – or $3.14 for fellow enthusiasts. The ring showcased here measures 9mm high and size 14. I have also included options for various sizes in case you prefer not to use the Customizer. Print Settings Printer: Rapide Lite 200 v1 Rafts: Yes Supports: No Resolution: 0.1mm (recommended) Infill: 100% Notes: Sliced with Cura, printed using silver PLA. My best results were achieved with a 0.1mm resolution; however, it can also be printed at 0.2 for fitting samples. Post-Printing After printing, carefully clean up the print with a knife to ensure there are no whiskers or bumps on the inside of the ring. Design Origins This design originated and concluded in OpenSCAD. Fun fact: The Triforce is created by subtracting a rotated cylinder of diameter D from a cylinder with diameter 2D... both cylinders are rendered with a "number of fragments" of 3, which reduces them to triangular prisms. Custom Section Customization Experiment with the Advanced Options if you wish to alter the ring's size or fine-tune other parameters. Troubleshooting If you're experiencing difficulties getting the ring to adhere to the raft, try adjusting the "Thinnest Layer" in Advanced Options. Licensing You are granted a Creative Commons Attribution-Non-Commercial-ShareAlike License. When uploading your design to Thingiverse, use the "Remix" feature. If uploaded elsewhere, please link to this page or pikaworx.com. I reserve the right to negotiate special licensing agreements.