Zelda Hyrule Relief Map Breath Of The Wild

cults3d

I combined every source I could find, and did a bit of elbow grease sculpting to get a map as realistic as I could. I'm going to make the buildings, bridges etc as soon as I get some time. (Updates will be here) Version 1 https://www.youtube.com/watch?v=Vm5peA9Dyb0 I don't have a nice movie highlighting Version 2 yet. Version 1) There are 2 STL's included. 1) a Skin Only version doe printing near vertically (opt for 30 degree angle off vertical as shown) 2) a Box version for printing flat on the plate directly. The box is tal, but you can always make it shorter by lowering it below the build plate (or cutting it to whichever height you want) Version 2) There are 3 STL's a) The map by itself (flat, not frame) b) The map in a box frame. This one I would suggest printing in vase mode (FDM) c) a flat "skin only" map with a frame around the edge. This version is mostly for resin printers where you would likely print it somewhere between 45 to 20 degrees from vertical. The STL's are scaled for the Mono X, but there is no reason you can't shrink or enlarge them to fit your printer. If there is interest, I'll happily add details and cut it up for you if you want to make a crazy big print. (Assuming you already have it of course, this thing took me a while :)