Zeepro Bushing

thingiverse

The Zeepro printer is a fun little device, but the designers made some compromises that can be frustrating. One of those shortcuts is not securing the 6 mm rods adequately, which causes them to push through the blocks and jam over time. I printed a couple of bushings for each rod, held together by M2x8 screws and nuts (though in my case, the holes threaded perfectly and I didn't need the nuts). Just install one bushing at each end of each rod to prevent it from sliding, and you're good to go. Print Settings Printer: Zeepro Rafts: No Supports: No Resolution: 150 mil Infill: 100 pct Notes: PLA works well for this project. I designed the parts in FreeCAD, which is an awesome tool!