Zalman Reflow Oven Controller V1 - Case for 3.2 LCD

thingiverse

This design is specifically created for the Zallus V1 oven controller, not the V2. The standard case from Thingiverse provides sufficient protection at the bottom, but this new design aims to safeguard the entire device and enable practical use. Screw holes in this case have a consistent diameter of 0.10 inches, making it easy to find suitable self-tapping screws that fit securely. The instructions for printing this case are relatively simple: Instructions: This case can be printed using standard settings or modified ones; I achieved excellent results with the following parameters: 20% Infill rate 5 Top layers for a smooth finish 3 Bottom layers for stability 2 outer shells to reinforce the structure Using Simplify3D for printing, but you may opt for Makerware's default settings as they can handle most of these specifications without additional adjustments. Additionally, this design allows for minimal or no supports needed during the printing process, and the flat bed area means rafts are usually not required unless you prefer to print with them anyway.