Z-Tops (no Bear Firmware needed) Bear Extruder and X axis 0.7.0-beta MK2.5S MK3S

thingiverse

I modified the Z-Tops for the Prusa i3 mk3s Full Bear so you won't need the Bear firmware, allowing you to run the (xy) Z Calibration with original Prusa Firmware. The thing has been thoroughly tested by me currently. If it works for you too, I would greatly appreciate your feedback in the comments. If you experience any issues, try lowering your PINDA to 0.9-1mm from the printbed while the nozzle is touching it. Also, ensure that your ZipTies are not obstructing the frame; there's limited space (see picture). For printing, I recommend using more infill than usual due to the thinner Z-Tops design. I printed with 50-60% infill and 0.15 layer height at 3 primeters. A 2mm Layerhight should also work well. Just try it out and have fun!