Z Stabilizer for Tornado/CR-10/... (608ZZ bearing)

thingiverse

This is a quick remix of TomExplorador's (LESS PARTS!) Frame Braces Titian & Creality CR-10 & ANET). I personally use it on my **Tevo Tornado** but since I didn't change the dimensions, it should fit **CR-10** etc. as mentioned in the original version. * **Support_CR-10_No_Z_Thread.stl**: Without Z-rod / bearing. Intended for any position that doesn't require a Z-rod hole or bearing, in my case it's used on the upper right (single Z setup). * **Support_CR-10_608ZZ_Bearing.stl**: With Z-road using the readily available 608ZZ bearing (instead of the one originally shipped with the printer). I use these modded versions on my Tevo Tornado, the _No Z Thread_ version on the upper right and the _608ZZ Bearing_ version on the upper left (single Z setup). As bottom parts I use those from Rear Frame support for Tevo Tornado. Note that, at least on the Tornado, these can't be used as bottom parts, since there are already screws in place holding the frame together.