Z Motor Mounts (Max Micron and other Prusa i3 clones)

cults3d

Improved motor mounts designed specifically for Max Micron Printers. My original acrylic mounts were satisfactory at first, but unfortunately, the right one began to sag over time, causing the rod and lead screw to become misaligned with every other component. This led to a critical issue where the Z lead screws would bind and prematurely wear out their nuts. To overcome these problems, I engineered new motor mounts featuring stiffeners and stabilizers that provide enhanced support against the frame. An additional hole is also included for an extra mounting screw if desired. It's likely that you won't need to install them directly up against the frame uprights; instead, simply measure off the frame to the center of the rod in multiple locations along its length to ensure accurate alignment and squareness.