Z Motor Mount SPACER - Tevo Tarantula - Z wobble fix

thingiverse

##Tevo Tarantula Spacer for the spare Z Motor Metal Mount. The 9.5mm option works perfectly for me, you may need to adjust the height in your slicer if required. You will need three M4x18mm screws and can use the original T-slot nuts. (Two top frame, one vertical frame) I used two washers for each motor screw because it's too big; you may choose to cut it if desired. ##How to Install - Home your printer first - In the controller menu, set the gantry height to about 100mm and holding the gantry, disconnect the motor coupler on the rod side. You can slowly place the gantry down as it will be held by the rod. - Remove your old mount - Install the spacer and the bracket, ensuring they are level with the top frame - Install the motor carefully - In the rod nut tab, loosen the two screws a little bit - Connect the rod to the motor - With the gantry at 200mm, hold the gantry up with one hand and wiggle the tab in place. Tighten it well. - You may need to readjust the tab. Test it up and down until you get minimum wobble. Subscribe to my channel for Fusion 360 tutorials: https://www.youtube.com/watch?v=4A2QvezsY5U