Z Limit spacer for eMake3D Galaxy 1 with a Wham Bam XTR

thingiverse

This is a spacer for the end stop interrupt spacer used for installing the Wham Bam Magnetic Build Plate for the eMake3D Galaxy One Resin 3D Printer. You will need to remove the center and left inside back panels to expose the bottom end stop sensor and interrupt bar on the build plate carrier. Install the block between the frame and the interrupt arm, use the screws that came with the Wham Bam plate since they are longer than the screws that were provided with the printer. - If you need to cut some screws, be sure that each screw is about 1/2 Inch long. Ensure that the interrupt arm is properly aligned with the z limit sensor opening. If these are out of alignment it can damage both parts.