Z Limit Adjuster for FT-5

thingiverse

This part replaces the bracket that holds the z-limit sensor on the Folgertech FT-5, allowing for precise adjustments in the printer's Z-axis. It is likely compatible with other 3D printers using a similar setup, but may require some adjustment to ensure smooth movement. The sliding parts are designed with tight tolerances, necessitating some sanding to achieve free motion. Two different sensor holders are provided, depending on whether you install them on the left or right side of the printer. To optimize your setup, consider checking out Dustin's dual-z-limit-switch mod for the FT-5 Z motor. You can find his mod page at http://dustincorbin.weebly.com/blog/folger-tech-ft-5-dual-z-stepperendstops-mod. For secure attachment, I recommend using small wood screws to screw the sensor holder into the melamine. Alternatively, you can use 3M automotive trim tape if you have it on hand and prefer a hassle-free installation. The goal is to allow for tiny adjustments in Z-limit height by turning the knob, making it easier to set the exact first-layer height. If this solution works for you, consider showing your appreciation with a tip that covers the cost of a cup of coffee, enabling me to continue creating new content. Your suggestions and ideas for improvement are also welcome.