Z Flip 5 Phone Case Holster Clip

thingiverse

Got out the old caliper and made this file because I accidentally broke the clip off of my ArmorBOX holster for the ZFlip 5. It's not an exact replica, but it does work, as I am currently using it. Turns out pretty decent with the following setting/material:Hot End: 220 cBed: 70 cPrint Speed: 60mm/sFan Speed: 50%Supports: Enabled; Normal; EverywhereMaterial/Brand: PETG/FIROS 1.75mm (Print Temp 190 c - 230 c)Placement: Place model on its side in Cura or whatever slicer you like.SPECIAL NOTE: Although this particular PETG material says it can be used at a range of temperatures, I have found through testing 4 full spools (2.2LBS/1KG), that the best results I achieved were while I printed Items at 220 c on the Hot End and 70 c on the print bed. If you choose a different material, just use whatever settings you usually do, should be fine.The item isn't 100% finished, but it is usable and works with a little bit of elbow grease.