Z Clamps for moving or shipping

thingiverse

To enhance the durability of your Z-couplers during shipment, we've introduced an updated version with a flange and nut slot. This new design requires only a hex head bolt and a wing nut, eliminating the need for tools to tighten or loosen. The clamp is derived from the Prusa iteration 2 bar clamp, with a modified hole for M4 screw compatibility. Included hardware: - x1 M4 30mm SHCS - x2 M4 washers - x1 M4 nut Instructions: 1. Attach the clamps to the smooth rod above and below both x-ends. 2. Insert a screw and washer through one end, followed by a washer and nut on the other side. 3. Tighten all clamps securely against the top and bottom of the x-ends for optimal performance.