Z BRACKET Remix (Tevo Tornado)

thingiverse

Here's a modified version that I came up with: All credit goes to Infectedfpv26 for this brilliant design. However, after installing a glass surface on my 3D printer, I encountered an issue where the z bracket and strain relief were touching the bed. This was quite frustrating, but it made me wonder if anyone else had experienced the same problem. As luck would have it, I managed to modify the original design to make it work for me. One side of the modified z bracket is thinner than the original, which allows it to fit snugly between the stepper motor and the inner side of the printer. To prevent any sharp edges from causing damage or injury, I rounded them off as well. While there's still room for improvement, this modification has resolved my glass bed problem once and for all.