Z-Brace for Monoprice Maker Select Plus

thingiverse

I've collected all of the components from both the parent project and the grandparent project. The parent project lacked the top braces and ball nuts, while two STLs were distorted - the front right was miniaturized and the back right didn't render correctly. These issues are now resolved. The pictures include the actual hardware I used: I purchased 1 set of metal glides (feet), 4-pack of 1-1/16 inch 8 Socket Cap Screws M3 x 0.5 x 12mm were needed - they come in packs of 3, so I bought 3 packs 4 Socket Cap Screws M5 x 0.8 x 12mm were required - they come in packs of 2, so I purchased 2 packs 1 piece of 36 inch 5/16-18 Threaded Rod was needed - it will need to be cut in half 4 pieces of 5/16-18 Nylock Nuts were necessary 2 pieces of 5/16-18 Regular Hex Nut were required For more information and guidance, check the parent project and the grandparent project. Important Note: While I print all of the components on a single bed, it's recommended not to print them all at once - if one piece jams halfway through, it will waste filament.