Z brace for migbot i3 (8mm acrylic frame)

thingiverse

Acrylic frames are fragile, making a z-brace an essential addition to enhance print quality. To create this support system, you'll need four distinct components printed with supports in place. These parts should be accompanied by the following hardware: * Four M3 bolts measuring 16mm each * Four corresponding M3 nuts A length of approximately 800mm of M6 threaded rod is also required, along with eight M6 nuts. Print Settings: The recommended printer for this project is the Migbot i3 (Electron i3). To achieve optimal results, consider the following settings: * Rafts: Not a critical factor * Supports: Yes, necessary for successful printing * Infill: Set to 60% for a balanced print quality