Z-AxisMotorMount

thingiverse

This thing was made with Tinkercad, and you can edit it online at https://www.tinkercad.com/things/g7pKpK5ssyI. This remix is based on thing:2204847 by arunasv. The key difference here is that the long surface mounts to the Z-frame using two screws, which attach to the Z-Axis Motor. The goal is to provide lateral support for the motor so it doesn't rotate out of alignment due to the mass of the gantry, extruder, and hot end. In Tinkercad, I removed the span that reached across to the far side of the z-axis motor and added a 2mm layer along the Z-axis for extra support. There are other ways to do this, like using the original part or adding support up the z-axis that gets secured higher. However, I was aiming to lift the motor for some extra Z height, and going much taller than arunasv's part starts encroaching on the Z-axis range of motion.