Z-Axis Offset Test Square 100mm x 100mm x 1mm

thingiverse

Use this file after leveling to do a live adjustment of the Z-Axis offset. Some suggestions: 1. Use a relatively high speed so you aren't waiting around forever to view the effects - 100-120mm/s should be good. You can always crank the speed up or down manually using your printer's display (if it supports that) 2. Take your time and observe the effect different heights have on both the bead as well as its blend with the neighboring lines. 3. Keep the same offset for at least a few lines back and forth so you can observe the effect and compare to the section before or after. 4. Once you find your Goldilocks height (see below), cancel the print. No need to finish. **Find your Goldilocks Bead:** - Perfect, round ropes and/or gaps between lines? **Too High** - Tape Worms, wavy or frilly edges, stripes of no extrusion? **Too Low** - Smooth Squish? **Just Right!** (see attached pic of red square)