Z and X chain mount for Anet A8

thingiverse

Here's my X and Z chain mount designed to use the chains from www.thingiverse.com/thing:2193695 and others. The chain files are included from that thing. YOU WILL NEED TO EXTEND WIRES! At least in my case I did and I made them too long. Get the chain here: https://www.thingiverse.com/thing:3179124 I put up a notated picture to explain some of the junk hanging out on the chain mount. This is my opto isolated board for the 12v sensor and a header block to connect the extruder heaters with a common positive so I only need three wires. I used twenty-gauge silicone wire and eighteen-gauge silicone for the common positive. This gives me six amps per line max when they draw four normally. I used Solidworks 2016 to make these. Included AMF files too. Thank you!