Z-5500 Speaker Mount for pole

thingiverse

This speaker mount is designed specifically for the Logitech Z-5500 speakers, except for the center speaker. It's meant to be mounted on a 35mm pole monitor mount, similar to those found on Newegg. I have two of these poles, allowing me to mount it on either side of my desk. Most people probably only have one, so this wouldn't make much of a difference unless they're mounting them right on top of each other. If I were to redesign this speaker mount, I think I would make the clamp slightly thicker to reduce stress after installation. However, I'm not too concerned about it. Print Settings: Printer Brand: Wanhao Printer: Wanhao Duplicator i3 V2 Rafts: Doesn't Matter Supports: Yes Resolution: .1 mm Notes: I recommend printing with supports. My print was done without them, with the back brace facing down and the clamp sticking up. I was worried about the angle being too steep, but there's some distortion on the inside of the clamp as shown in the photos. This won't be visible anyway since it will always be hidden from view. Despite this, my print turned out better than expected without supports. If you're looking for a perfect print, I suggest using supports or possibly a high-end printer to get even better results.