Yuneec Q500 ST10+ Gimbal Cover

thingiverse

I searched every corner for covers to shield the Yuneec ST10+ gimbals. Using an aftermarket case, I worried that the clearance for the sticks might snap them in two. Plus, I needed protection when using a backpack to reach a remote location. On my ST10+, these fit snugly over the standard gimbal and stick. If it's too loose or tight, I've included a simple ring I printed multiple times until getting the diameter right. Simply resize it and print until you get it just right, then resize the actual cover by the same amount. Use medium supports, no raft, 20% infill, and whatever resolution suits your needs. I used my lowest setting and it printed flawlessly. Sand to taste. Print Settings: Printer: Davinci 1.0A Rafts: No Supports: Yes Infill: 20%