Yu-Gi-Oh Duel Disc (master rules 5 and below)

thingiverse

LEGAL STUFF: BY DOWNLOADING THE FILES FROM THINGIVERSE, YOU AGREE TO THE FOLLOWING TERMS AND CONDITIONS: The files are for private use only. You are allowed to print parts from them for your personal use only. You are not allowed to use these files or parts you printed with the use of this file in any commercial way. If you are distributing pictures from parts or models you build with these files, you are only allowed to do so if you declare the source of the design. You must add a link to this thingiverse-thing in the description of your photos! You are not allowed to copy or distribute them in any way. You are not allowed to sell them or parts you printed from them or models you build with the use of these files. DESCRIPTION: IT'S TIME TO DUEL!!! This is a simple and small duel disk for the Yu-Gi-Oh card game. Playable with Master Rules 5 and below. Works with sleeved cards as well as with unsleeved. Measures 400x150x120 mm (length x depth x high). Very easy to print on 20^3 cm printers, no supports needed. The only place where supports are needed is the top of the monster zones, but I added some small supports there which you have to cut away with a small cutter. To keep the duel disk small, there is no space to tap the cards. To show which ones attack and which one defend, I added small turnable disks with an attack symbol (sword) and one to defend (shield). The extra monster zones are retractable. There is place for a deck up to 40 cards and the same space on the graveyard, but I split the graveyard in two. If you want to use a larger deck up to 60 cards, you can use part of the graveyard for the extra cards and use the space as graveyard when you have played the cards from there. Printing recommendations: Print time for all parts is approximately 24 hours, with the card holder as the biggest part needing 12 hours. Print without supports and 10% infill. Print the monster zone and the card holder standing upright on the inserts of the cards, and the extra monster zones also standing on their card insert on the front. Print the arm holder standing upright with the side for the connector with the chamfer facing to the bed. You need to attach two straps to the arm holder to fix it to your arm. Maybe add some soft material on the inside for more comfort. Assembly: Insert the extra monster zones from the back, they will snap in in the back and can then freely moved out when needed and retracted when not. Insert the markers from the front with the pin facing down and the symbols up. Carefully lift the bottom of the monster zones a little bit with a screwdriver. Be aware that there are two different disks. The ones with the two x four symbols (print each 2 times/marker2) come above the extra monster zones, the ones with 2 x 1 symbol (print 3 times/marker1) come to the other zones. Place the bigger connector in the monster zone and glue both parts in the card holder. Place the two smaller connectors in the armholder and glue it to the card holder. Finished. Have fun duelling and may the force be with you!