Yu-Gi-Oh Card Trophy/Stand - REMIX

thingiverse

I printed the original card holder which is a great design, however it barely seemed to hold the card in place so I designed this replacement holder that fits the original stand. Just print 2 and slide them together, they may need a little sanding mine have all had little peaks on one end where the nozzle lifted and left a small glob. I'm using a similar design to make a Magic the Gathering holder but it's not ready yet. Print Settings Printer: Da Vinci 1.0 Rafts: No Supports: No Resolution: 0.2 Infill: 20% Notes: This would probably come out much better at 0.1 layer height, but since I'm just prototyping, I haven't used that setting yet.