Yootech Charging Stand (Triangular style)

thingiverse

If you're like me, you probably debated between getting a lay flat or upright wireless charger. And if you're like me, you likely ended up with the lay flat design, which works fine but has its downsides. I designed this to hold the charger firmly in place, applying just enough pressure to prevent it from coming loose. My model will pop in and out without much effort, but it stays put when picked up or carried around. However, I doubt it would stay in if you shook it vigorously, so please handle with care! There are two models available: V1 Slightly smaller and lower profile Vertical phone orientation only USB plug located at the top (cable can be run through the top support hole then the lower USB hole) V2 Slightly taller Both vertical and horizontal phone orientations USB plug situated at the bottom, with the cable running underneath the stand Please note that I made a few minor changes to V1 after taking the photos but didn't create a new print. Specifically, I modified the rear vertical support to match the style of V2 and added a small hole at the bottom for the USB to pass through. The alignment of the charger in the stand was designed with my LG V30 in mind. The front phone area has some extra room, so it should fit most modern phones, including those in a thin TPU-style case (the phone area measures approximately 84mm wide by 12mm deep). I'm not aware of how much variation there is in the vertical location of the wireless charging coils inside different phones, so I can't say for certain which other phones will line up correctly. However, I've included some test files that you can use to do a fit test before printing the full design. If it works with your phone, please let me know and I'll add it to the list below. Phones that work (as of December 27, 2018): LG V30