Yokomo YD2 MST RMX 2.0 RC Body Display chassis 1/10 scale drift

thingiverse

This is modeled after a Yokomo YD2S chassis. The front hub to hub is 175 mm with 10 degrees of camber. The rear is 170mm hub to hub with 5 degrees of camber. The intent is to display my extra bodies, with the ability to use magnetic mounts like I do on the chassis. You dont have to add the magnets, but why not. The typical body posts are 20mm in the front and 40mm in the rear. Other lengths are included. Use 4/40 x 3/8th long screws (x 8) for the posts and to adjust the mounting height. Use 4mm pan head screws that are 10mm or longer for the axles/ wheel. Just screw them right into the print. You can sub 6/32 also. Hold the two halves together with 4mm x 16 or longer screw and nut or 6/32. I included the typical angle plates, I do have other angles if needed. You just want to be close. No supports need, can print everything at .3mm height,