Yi Ants cam 45 degrees angle mount

thingiverse

I needed a 45-degree mount for my Yi Small Ants security cam, so I decided to print one that would fit snugly between a gate and a wall. The cam itself will fit tightly into the hole, but you can also print the walls to provide extra stability - it's not strictly necessary, though. Make sure to use the support at least inside the hole for added strength. I printed with adhesion layer to get a strong bond on the bottom of the case too. If you're using this outside, seal the mount with silicone around every edge to keep water out. Adding a fuse can also prevent short circuits. Don't worry about the top and bottom caps - they snap into place perfectly and are designed to be very tight so water can't get in and damage your camera or power supply. You'll need a 90-degree flat USB cable to close the case properly.