Yeti Blue Mic Desk Arm

thingiverse

Here's a remix of the Phone Mount by doctriam - its arms are surprisingly strong. Strong enough to hold up the Yeti Blue microphone! To ensure maximum durability, use at least 85% infill on parts nearest the desk connector and supports are highly recommended. I originally used 24% infill PLA and one of the threaded rods broke, but 85% held up great! The desk connector part requires 4 small common wood screws. The holes are off-set and the width between the two side pieces matched the MDF on my particular desk. To print it upright is crucial, and use some pliers to pop out the temporary supports on the desk attachment. When attaching the mic, use the little rubber washers between the mic itself and the printed part. The dimensions match the holder that the mic comes with so it fits together in exactly the same way.