Yet another layer fan for Sparkcube with E3D v6 (Single Tip)

thingiverse

This is another version of my layer fan for the Sparkcube printer. It's made specifically for 40mm fans and I discovered this design works slightly better than my other one which blows downwards on the object. Instead, this design blows air across the object after passing through the nozzle tip. Print Settings: Rafts: They don't matter. Supports: None Resolution: 0.2 millimeters Infill: Thirty percent Notes: I add support to only the two mounting lashes, not inside the housing. If you're printing this one without a fan - and that's likely since you're printing it - just print once without one and it will still work. But it won't look great. Then, print another time with the ugly fan attached for a better-looking result.